Commax Dp-ra01 Installation Manual -

Push the handset flush against the wall and slide it down firmly until it clicks into place.

The Commax DP-RA01 is an outdoor door camera module designed for use with Commax digital video intercom systems. It provides HD video, two-way audio, and a durable, weather-resistant housing. This guide covers standard surface-mount installation.

Connects to Terminal 1 on the outdoor unit (Audio/Signal line). commax dp-ra01 installation manual

Up to 50m with 0.65Ø cable to the door station, and 30m to a sub-station. Mount Type: Surface mount. 華輝電子(集團) 有限公司 2. Wiring & Connection Guide

The Commax DP-RA01 is a 1-to-2 audio doorphone system consisting of a master room station (DP-RA01M) and an optional sub-station (DP-RA01S) Push the handset flush against the wall and

Loosen the screws on and Terminal 2 at the back of the DP-RA01 handset.

Connect the wires to the terminal block on the back of the DP-RA01 handset according to the wiring plan outlined in Section 3. Ensure the screw terminals are tight and no stray wire strands are touching adjacent terminals. Step 5: Mount the Handset This guide covers standard surface-mount installation

: The master unit (DP-RA01) typically plugs directly into a standard AC 100-240V

2-wire system to the door camera/sub-unit (non-polarity).

Connect these terminals in series with an external power supply and your electric door lock. Circuit Path: Positive terminal of lock power supply →right arrow Terminal 3 →right arrow Terminal 4 →right arrow Positive terminal of electric strike →right arrow Negative terminal of lock power supply back to source. Step-by-Step Installation Procedure