Instructions on using the dial calculators on the side of the machine to shift the geometric speed steps (ranging from 40 to 2000 RPM on standard models).
One of the most powerful features detailed in the Deckel FP2 manual is its ability to switch seamlessly between horizontal and vertical milling modes. Using the Horizontal Spindle
tapers for both horizontal and vertical spindles, though early versions may use Morse Taper 4 (MT4). Spindle Orientation: deckel fp2 manual
Before operating the machine, refer to the primary specifications listed in the manual to understand its physical and mechanical limits. Specification Metric Measurement Imperial Equivalent 15.7 inches Y-Axis Travel (Transverse) 7.8 inches Z-Axis Travel (Vertical) 15.7 inches Spindle Taper (Horizontal & Vertical) SK40 / DIN 2080 MT4 (Rare, early models) Spindle Speed Range 40 – 2000 RPM (18 steps) 40 – 2000 RPM Feed Rate Range 8 – 400 mm/min (18 steps) 0.3 – 15.7 inches/min Rapid Traverse Rate 1200 mm/min 47 inches/min Main Motor Power 2.2 kW / 3.0 HP 2.2 kW / 3.0 HP Machine Weight (Approximate) 900 to 1100 kg 1980 to 2425 lbs 3. Understanding the Control Interface
If there is one section of the Deckel FP2 manual that demands absolute adherence, it is the lubrication chart. These machines were built with incredibly tight tolerances. Running an FP2 dry or using the wrong type of oil can result in permanent, expensive damage to the precision ways and gear trains. Daily Maintenance Tasks Instructions on using the dial calculators on the
The FP2 uses a sophisticated dial-shift system for changing speeds and feeds. Shifting gears incorrectly or while the machine is under load can shatter internal gears that are incredibly costly to replace.
What are you looking to service? (e.g., electrical schematics, spindle disassembly, or table alignment) Spindle Orientation: Before operating the machine, refer to
The feed drive shaft features a mechanical safety slip clutch to protect the gears during a crash. If this slips too easily, it must be adjusted according to the manual's torque specifications using the internal notched spanner nuts. Issue 3: Excessive Noise from the Drive Train
I can provide targeted instructions or part-location details from the manual for your specific project.
: Roughly 1,000 kg to 1,200 kg depending on the specific model and accessories. Key Sections of the Deckel FP2 Manual FP2 2202 conventional, standard X-400 mm -