+---[DC Power Source]---+ | | [MOSFET 1] [MOSFET 3] |-------(LC Filter)-----| [MOSFET 2] [MOSFET 4] | | +---------[GND]---------+ Component Checklist
By following the steps outlined in this guide, you will be able to:
In the dialog, enter:
At the heart of the EGS002 is a symbiotic partnership between two primary chips:
Place a power inductor (typically between 1mH to 3mH) in series with the H-bridge output. egs002 proteus library
What and target AC output voltage are you using?
If the library comes with a .DLL simulation model, copy that file to the MODELS folder as well. +---[DC Power Source]---+ | | [MOSFET 1] [MOSFET
Since the EGS002 is built around the EG8010 chip, many users search for the part in the Proteus library. Some versions of Proteus (specifically newer or "professional" patched versions) include the DIP-28 or SOP-28 footprint for the EG8010. If found, this allows you to simulate the logic signals (SPWM outputs) that would eventually drive your H-Bridge MOSFETs.
within Proteus to provide the necessary 5V and 12V rails required by the real board. Pro-Tip: Check the Oscillator Since the EGS002 is built around the EG8010
Connect Channel A to one side of your LC filter and Channel B to the other. Set the oscilloscope to "AC" mode.