: If the display appears shifted to one side after updating, you likely have a different hardware version of the screen. FNIRSI released two variants of V3.0 to account for different display manufacturers. Re-updating with the alternative V3.0 file usually fixes this.
: Using the recommended cable, connect your FNirsi-1014D to your computer.
If you want, I can:
I disconnected the cable and hit the power switch. The FNIRSI logo flashed twice. A thin horizontal progress bar crept across the bottom of the 7-inch screen. It took less than a minute, but in the silence of the lab, it felt like an eternity.
Copy the firmware file directly to the root directory of the SD card. Do not put it inside any folders. fnirsi1014d firmware update work
Unplugging the cable while the .bin file is writing will result in a corrupted flash memory. This creates a "bricked" state where the device will no longer turn on. Always use the "Safely Remove Hardware" option before disconnecting. Official vs. Custom Open-Source Firmware
Elias didn't want to just use the scope; he wanted to perfect it. He took to the forums—EEVblog, Reddit, the dark corners of Russian and Chinese electronics boards. This was the "underground" of oscilloscope ownership. : If the display appears shifted to one
How to Make the FNIRSI-1014D Firmware Update Work: A Step-by-Step Recovery and Upgrade Guide
Click or "Flash" and wait for the progress bar to reach 100%. Step 4: Finalize and Reboot Disconnect the USB cable from the oscilloscope. : Using the recommended cable, connect your FNirsi-1014D
On the oscilloscope menu, navigate to MENU > USB export . This will make the device appear as a new drive (typically 8GB) on your computer.