Hager Controls Bp 10140 Manual Link 〈VALIDATED – 2024〉

Feature a large 24-hour dial with small pins (tabs) representing 15-minute intervals. Pushing these pins in or out sets the "on" or "off" schedule.

The is not a specific model number, but rather a reference to the manufacturer's postal address (B.P. 10140) located in Saverne, France . This address appears on various Hager device manuals, including timers like the EG103 , EHN011 , and the B.IQ push button display.

: You can search by the actual product reference to download PDF technical documentation. Hager Support Site International Downloads Page hager controls bp 10140 manual

: Allows for precise timing of electrical loads, such as lighting or heating, using a digital interface.

Therefore, when you see "Hager Controls BP10140 67703 SAVERNE CEDEX FRANCE" printed on a device or in its documentation, it is simply the manufacturer's address. This address appears on a vast range of Hager products—from motion detectors and timers to KNX system components and DALI control modules—serving as their official manufacturer’s mark. Feature a large 24-hour dial with small pins

Hager BP 10140 is not a specific model number for a control device, but rather a part of the corporate address for Hager Controls S.A.S.

| Issue | Possible Cause | Suggested Solution | | :--- | :--- | :--- | | Light stays ON continuously | Movement constantly detected; or light threshold setting too high; or device in Test mode | Check for heat sources or vibrations in detection area; adjust response brightness; confirm device is not in test mode | | Light does not turn ON | Light threshold set too low; load not connected; power supply issue; or detection zone not covered | Increase response brightness setting; verify load wiring; check power supply; walk test detection area | | Unexpected switching | Interference from heating/AC systems, cooling lamps, or vibrations | Relocate or shield device from air currents/heating elements; mount away from vibrating surfaces | | KNX device not responding | Incorrect physical address; ETS configuration mismatch; bus connection issue | Check KNX bus wiring; verify device addressing in ETS; reload application software | | Master/slave devices not synchronized | Incorrect wiring; slave devices not in range; parameterization issue | Verify PB/SL wiring between devices; check number of slaves (max ≤10); review ETS parameters | 10140) located in Saverne, France

Connect the (typically brown or black) to terminal L . Connecting the Switched Load