Kes Geyser Load Control Timer Manual New !!better!! 【480p 2025】

To set additional profiles (up to 16 slots), press again to access 2 ON , 2 OFF , etc.

Ensure the main circuit breaker feeding the timer is turned ON. Let the unit charge for 15 to 30 minutes, then press the Reset pinhole button to clear the memory and reboot the CPU. 2. The Geyser Turns On at the Wrong Times

is an efficient, reliable solution designed to automate your geyser, reducing electricity usage by limiting operation during peak times .

Press the button to return to the current time display. 4. Setting Operation Mode (Auto/Manual) Press the Manual button to cycle through modes: ON: Geyser is permanently ON. OFF: Geyser is permanently OFF. kes geyser load control timer manual new

Before programming schedules, you must configure the internal clock to local time.

ON 17:00 | OFF 19:00 (Hot water for dishes and evening baths) Mid-day: Keep OFF to avoid "standing heat loss."

Electrical work should be performed by a qualified electrician to ensure compliance with local regulations. Troubleshooting & Tips To set additional profiles (up to 16 slots),

Press to select the day(s) you want this setting to run (e.g., Monday-Friday, or individual days).

Press and M+ to set the time you want the geyser to turn off (e.g., 06:00 ). Setting Program 2 (Evening Heating Cycle) Press the P button again to move to 2 ON . Select your day block using D+ . Set the evening start time using H+ and M+ (e.g., 17:00 ). Press P to view 2 OFF . Set the evening turn-off time (e.g., 19:00 ).

The KES timer is designed for DIN rail mounting inside your distribution board or a dedicated weather-proof box. Wiring Diagram Basics: Before programming schedules

Press and M+ to set the time you want the geyser to start heating.

The internal battery may be flat. Leave the unit connected to power for 10 minutes to charge. If it stays blank, press Reset.