|
|
|
|
|
| Parameter ID | Description | Typical Range / Values | |--------------|-------------|------------------------| | VehVIN | Vehicle identification number | 17 chars | | EngModelCode | Engine model | DC13, DC16, etc. | | EngPowerMax | Max engine power | 370–770 HP | | EngTorqueMax | Max torque | 1800–3700 Nm | | EngIdleSpeedAdj | Idle speed adjustment | 500–900 rpm | | VehSpeedLimit | Max vehicle speed | 80–90 km/h (EU) | | CCSpeedLimit | Cruise control max set speed | 85 km/h | | PTOEngSpeed | PTO target engine speed | 800–1500 rpm | | EcoRollEnable | Eco-roll function | 0=Off, 1=On | | IdleShutdownTimer | Auto engine stop after idle time | 1–60 min | | HillHoldActive | Hill holder enabled | 0/1 | | RetarderSteps | Number of retarder levels | 0–5 | | AdBlueDosingEnable | SCR system active | 0/1 | | DPFRegenType | Regeneration type | Auto/Manual | | GearShiftProgram | Transmission shift pattern | Economy, Power, Off-road | | AxleRatio | Rear axle gear ratio | 2.59, 2.92, 3.08 | | TyreCircumference | For speedometer calibration | mm | | DaytimeRunningLights | DRL mode | 0=Off, 1=On | | LDWSensitivity | Lane departure warning | 0–3 (low-high) | | AuxOutput1Function | Configurable auxiliary output | Headlight flash, beacon, fan |
Includes parameters for clutch wear measuring, slip, and overload warnings. AWD / PTO:
Manages settings for daytime running lights and headlamp cleaning cycles. Scania Sops File Parameter List
For example, a parameter might look like this in its raw form: 00-01-02 [Value: 03]
For example, a new parameter for over-acceleration protection bypass on gas vehicles can be found under "Electrical system > Engine management system > EMO2 > adjustment". | Parameter ID | Description | Typical Range
When working with SOPS files, issues can occasionally arise, particularly when replacing ECUs. The four most common problems include:
Crucial parameter when physically swapping the rear differential gear set. If this parameter does not match the physical gear ratio, the tachograph and EBS systems will throw critical speed-mismatch faults. For example, a parameter might look like this
: Toggles the Selective Catalytic Reduction system.
: Controls maximum torque output in specific gears to protect the transmission.
"Give me the SOPs file," Lars said.