To enter programming mode, you must use the . The factory default Master Code is 999999 .
: Save this new password in a secure location. If forgotten, perform factory initialization to reset to 12345 .
An anti-tamper switch is located on the circuit board. When the back plate is securely attached, the switch is depressed and silent. If the device is forcibly removed from the wall, the switch will pop out and the unit will emit a continuous buzzing alarm. V2000-c Rfid Access Control User Manual
A: Check the J1 relay jumper settings (Part III). Ensure the jumper is set to NO if you are using an electric strike lock that requires a momentary closed circuit.
Sets the authentication method to require BOTH a valid card AND a valid PIN code for entry. To enter programming mode, you must use the
The V2000-c uses a star-prefix command structure. [Master Code] + [#] .
To modify settings, you must enter Programming Mode. While in this mode, the indicator light changes color (typically flashing orange or red). If forgotten, perform factory initialization to reset to
A: No. The reader hardware is specific to one frequency. Check your model: V2000-c-EM (125kHz) or V2000-c-MF (13.56MHz Mifare).
Ensure the backplate is firmly secured against the wall to depress the tamper switch. Check input voltage with a multimeter to ensure it reads a stable 12V DC. Keypad Fails to Accept Master Code Cause: The default master code was changed and forgotten. Hard Reset Procedure: Disconnect the power source. Press and hold the # key while restoring the power. Release the # key after hearing two short beeps.
You now hold the equivalent of an advanced training course for the . This user manual has walked you from the screw terminals of the relay to the logic of anti-passback and multi-card open.
